How to Use Autel DS708 to Reset Toyota Camry 07-10 TPMS

By | July 12, 2016

The tire pressure warning light blinks for 1 minute and stays on to indicate a tire pressure monitoring system malfunction after driving for about 20 minutes. If the ID code of the tire pressure warning valve and transmitter is not registered, the tire pressure warning system will not work properly. Following part are the detail instructions on resetting Toyota Camry (2007-2010) TPMS (Tire Pressure Monitoring System) indicator light with Autel MaxiDAS DS708 diagnostic scanner.


Autel DS708 OBD2 diagnostic scan tool
Toyota Camry transmitter ID code
Ps: Where is the tire transmitter ID code located?
You need to copy the id code from the tire pressure sensor. It is stamped on the side of the sensor.)
Well install Autel DS708 software
Connect the DS708 scan tool with vehicle via OBD socket
Power on the device and browse to “System Menu”


Find out and locate “Tire Pressure Monitor” option in “System Menu”
Select Utility
Select ID Registration
The tire pressure warning valve and transmitter is equipped with a unique ID code. When replacing a tire
pressure warning valve and transmitter, it is necessary to register the ID code.
Registration will fail if the time limit is exceeded for any step. Press OK to proceed.


Press OK to begin the registration process.


The system warns that you have 5 minutes to complete 3 procedures:

— Input each transmitter ID code
— Input next transmitter ID code
— Wait all ID code are registered.


Manually enter the transmitter ID follow the system prompts, and press OK
Step 4 of 4
Input the transmitter ID Code
Total Tires: 4
Register Tires:1
Press OK to input another ID Code.


Enter 4 ID codes one by one until the system will display ID Registration is complete message.


Go back to “Function Menu”, select “Read Codes” and then erase fault codes. TPMS indicator light has been disabled. The indicator light on dashboard go off.

More details, please check below
Whatsapp: +86-13429866263 (Stacy)